Water-based tough hard wearing finish for walls and floors

Remmers BS3000 is an amazing tough high build epoxy coating for walls and floors in Silk Gloss. Use on any surface including damp concrete to get a tough coloured hard wearing finish.

RAL 3001 Signal Red.

Water based and very very easy to use. Use this product for all locations where you require a hard wearing dust free coating.  It can be used to paint over screeds, concrete, timber, plasterboard, bitumen, tarmac, most other paints.

DIY Applications

• Garage floor paint
  
• Workshop floor paint
  
• Utility room floor paint
• Wall paint
• Screed paint
• Concrete paint
• Timber paint
• Plasterboard paint
• Bitumen paint
• Tarmac paint
• Goes over most other paints

Professional Applications

• Aircraft hangar floor paint
  
• Car park floor paint
  
• Car showroom floor paint
  
• Warehouse floor paint
  

Features

• Very Fast drying
• No primer needed
• Clean tools with water
• Silk finish
• Solvent free
• Very easy to apply
• Good chemical resistance
• Slip resistant additive available

How to Step-by-Step

1. Clean up the floor, remove dust, oil or grease which may reduce the bond.
2. Open the base and hardener components using pliers.
3. Thoroughly mix the two together with a drill and paddle paint mixer.
4. Apply by short pile roller to the floor.
5. Clean tools with water.

The paint will be touch dry in 2 hours and ready for foot traffic in 8 hours. Normally 2 coats is advised for the best finish. Allow to dry between coats.