Get rid of damp from your cellar or basement!

Sulfatex Grout Rapid from Remmers is a slurry which, when brushed on to damp walls in 2 or 3 coats with a rapid 20 minutes in between, will give you a fully damp-proofed basement in no time.
Use Remmers Aida Kiesol as the primer. Surely the only way to make your room dry?
A very clever cement based powder in a bag. Mix with water into a brushable slurry and brush onto damp walls which have been primed with Aida Kiesol.  Super fast drying - you can waterproof your cellar in a day. The bond to the wall or floor is so strong that even high pressure water cannot get through.
Uncomplicated, fast and so easy to do! Use only on mineral surfaces such as stone, brick, rubble, concrete and such like.

What can I use it for?

• Cellar wall waterproofer
• Basement wall waterproofer
• Brick wall damp-proofer
• Stone wall waterproofer
• Rubble wall waterproofer
• Concrete wall  waterproofer
• Floor waterproofer
• Waterproof underneath floor finishes
• Tank waterproofer
• Bund waterproofer

How do I use it?

1. First ensure that walls are free of anything which will stop the slurry sticking, like paint, varnish, oils or other finishes. Remove these either by grinding or paint stripping.
2. Prime the walls and floor with Kiesol.
3. Open the bag of slurry and mix the powder with water using a drill and whisk.
4. Brush onto the surfaces.
5. After 20 minutes to 1 hour you should apply a second coat of freshly mixed material.

Get rid of damp from your cellar or basement!

Simply brush this slurry on to damp walls in 2 or 3 coats allowing just 20 minutes in between and you have a fully damp-proofed cellar or basement in no time. Use Remmers Aida Kiesol as the primer.

Surely the only way to make your damp room dry?

A very clever cement based powder in a bag. Mix with water into a brushable slurry and brush onto damp walls which have been primed with Aida Kiesol. Super fast drying - you can waterproof your cellar or basement in a day!

The bond to the wall or floor is so strong that even high pressure water cannot get through.

Check out the cellar waterproofing brochure, this truly is the only sensible way to make your basement or cellar dry. Uncomplicated, fast and so easy to do! Use only on mineral surfaces such as stone, brick, rubble, concrete and such like.

What can I do with it...

• Waterproof cellar walls
• Damp-proof brick walls
• Waterproof stone and rubble walls
• Waterproof concrete walls
• Waterproof floors
• Waterproof underneath floor finishes
• Waterproof tanks and bunds
• Stop water getting in or out

How do I use it?

1. Make sure the walls are free of anything which will stop the slurry sticking, such as paint, varnish, oils or other finishes. Remove these either by grinding or paint stripping.
2. Prime the walls and floor with Remmers Aida Kiesol.
3. Open the bag of slurry and mix the powder with water using a drill and whisk.
4. Brush onto the surfaces.
5. After 20 minutes to 1 hour you should apply a second coat of freshly mixed material.

Get rid of condensation on walls!

Remmers Restoration Redner is an antique white 'base coat' plaster which allows a whole lot of moisture and condensation to be stored inside since it is almost 50% air void.

Restoration Render is perfect for re-plastering after damp-proofing works it absorbs vapour and condensation and stops salts coming through. Lightweight and easy to use.

Fibre reinforced one layer restoration render/plaster suitable for the repair, renovation and restoration of damp wall surfaces.

Really easy to use in a single layer up to 30mm thick!

Makes a great general purpose render and plastering material. The huge amount of air voids in the applied material mean that condensation will become a thing of the past.

Use inside and out. Overcoat with other plaster or just paint – no problem!

Antique White colour.

What can I do with it?

• Replastering after DPC works
• Plaster onto waterproofing
• Render onto waterproofing
• Textured finish render
• Textured finish plaster
• External render
• Insulating render
• Salt storing render
• Stop condensation on walls

How do I use it?

1. Just mix with water
2. Best to read the data sheet first

Grab yourself some Damp-proofing Plaster – Remmers Restoration Render

Range of Use

Remmers Restoration Render Rapid can be used for fast repair, renovation and restoration of
damp wall surfaces, even with salt loads such as:

• Internal wall surfaces in cellars and old buildings
• For facades, historical buildings and monuments
• Also for high salt loads when used in combination with Remmers Undercoat Render
• For the Pros: It can be used on all mineral wall building materials suitable for the application of render such as masonry brick, also with pores, sandlime brick, concrete according to DIN 1045, aerated concrete, masonry work with natural building materials suitable for render, building materials with carbonate and hydraulic setting binders according to DIN 1164 and DIN 1060.

Damp-proofing Render benefits

• Binds water fast and can be worked over quickly
• Coatings or finishing render can be applied after just 24 hours
• The render sets and develops its hydrophobic properties even in > 60% humidity
• Easy to apply and work the surface in one layer up to 30 mm!
• Can be worked by machine
• High stability
• Fibre and texture reinforced; sets and dries crack-free
• Promotes drying, resistant to salt and sulphates with large active pore space volume (> 50%)
• Prevents the loss of heat through the penetration of moisture ▪ Condensation does not
  form on the surface
• Water, weather and frost resistant
• Component in a fast, internal waterproofing system

Grab yourself some Damp-proofing Plaster – Remmers Restoration Render

Super quick waterproof plugs in 15-20 seconds

If you need to plug up mortar or concrete quickly the Remmers Aida Water Stop is ideal.

Aida Water Stop is a ready to use powder. Applied by a gloved hand as a dry 'bung' into a wet hole it reacts with water instantly and sets hard. For rapid sealing of leaks, seepage of water, flowing water on concrete, masonry work and render in cellars, water tanks, tunnels and such like.

Aida Water Stop reacts immediately with water and in the space of 15-20 seconds at room temperatures. It sets hard to a 'plug' of mortar which dries without shrinking and therefore stops further leakage. Aida Water Stop is is fine for concrete and masonry work. It is water impermeable and frost resistant after thorough drying and hardening. Does not rot or shrink.

For leaks in a floor or wall, just press a small amount of this Water Stop in a gloved hand into the weeping crack, hole or leak. Water Stop then sets to a hard plug which will resist water leaks for many hours and days. This is long enough to apply a permanent waterproof slurry over the top.

Using it on its own it is a temporary plug, designed to be overcoated with a permanent tanking layer.

Aida Water Stop is essential stuff for fixing wet basements!

Quick, I've got a weeping hole to plug! Get Water Stop Fast Setting Cement now!

Merry 10th Day of Christmas!

On the tenth day of Christmas,

my true love sent to me...

Ten Lords-a-Leaping
Nine Ladies Dancing
Eight Maids-a-milking
Seven Swans-a-Swimming
Six Geese-a-Laying
Five Gold Rings
Four Calling Birds
Three French Hens
Two Turtle Doves
And a partridge in a pear tree.

DIYsupermarket.com version...

On the tenth day of Christmas,

my true love sent to me...
Ten Chaps-a-Flooring
Nine Drillers Drilling
Eight guys a-patching
Seven Scrubbers Scrubbing
Six Geezers Spraying
Five strange things
Four Rolling Birds
Three Bench Saws
Two Rubber Gloves
And a Sikaflex cartridge in a pear tree.

Damp-proof your walls with our maxi kit

Our maxi damproofing kit includes 5 x 310ml Aida Injection Cream, a Cartridge Gun and is complete with an Injection Adaptor and Nozzle!!

You can easiliy stop rising damp in its tracks by simply squirting Remmers Aida Injection Cream into drilled holes in your brick mortar joints. Drill, inject and the job is done! No more rising damp will occur. Remmers Aida Injection Cream is the original, best and now the cheapest!

Create a dry zone in your walls and stop rising damp now!

Water based emulsion damp-proofing injection cream. Very easy to use to stop rising damp in walls. Based on a silane / siloxane paraffin emulsion. The product contains the perfect amount of active ingredient to make walls impenetrable to rising damp.

DIY Applications

• Wall damp-proofing
  
• Damp patch stopper
  
• Stone damp-proofer
• Brick damp-proofer
• Masonry damp-proofer
• Rubble wall damp-proofer
• Suitable for most walls, bricks, stone etc.
  

How to Step-by-Step

1. Drill a hole into the wall along the line of the mortar joint
2. Slot the cartridge into a sealant gun
3. Attach the adaptor and nozzle
4. Squirt the Remmers Aida Injection Cream into the hole.

Job done. Allow to soak in over the next hour or so and the reaction of the product with the water in the wall forms an invisible pore liner which stops water travelling up through your wall. No more damp!

Buy our Maxi Damp-proofing Injection Kit

Get a Grip with this slip resistant additive

Unique Remmers slip resistant additive for all kinds of floor paints. Empty these round polymer beads into the paint as you mix it and then just roller the floor paint onto the floor in the normal way. The polymer beads disperse evenly and give a perfect light anti-slip floor which is still easy to clean.

Anti-Slip Additive for Paint ADD250 was specifically designed for Remmers Epoxy BS3000 and Epoxy PH coatings, but also effective as an anti-slip additive for other floor and wall paints.

DIY Applications

• Epoxy floor paint anti-slip additive
• Paint anti-slip additive

How to Step-by-Step

1. Tip the beads from the 250g pot into the paint.
2. Mix it in thoroughly with a paint mixer
3. Roller the paint out onto the floor, from a paint tray or paint kettle.

You will get a lovely uniform finish as the beads disperse themselves evenly through the paint as it rolls out. Easy!

Buy Anti-Slip Additive for Paint ADD250