Watch the video to see how easy it is to create a tough, great looking floor for your garage, workshop or utility room. Just like a car showroom!

How to Step-by-Step

1. Remove loose coatings from the floor by sanding or grinding
2. Hoover up the dust and particles
3. Open both the resin and the hardener and pour the small tin into the larger one
4. Mix with drill and mixing paddle
5. Apply by roller to the floor. Discard any mixed but unused material.
6. Allow to harden before use.

You will need

1. Drill mixing paddle
2. Epoxy roller
3. Epoxy BS 3000 SG Floor Paint
   

Amazing tough high build epoxy coating for walls and floors. Silk Gloss. Can be used on any surface including damp concrete to get a tough coloured hard wearing finish.

Any colour from the RAL colour matching system you like at no extra cost within 24 hours. Water based and very very easy to use.

Just state the colour you require when ordering, and we will tint the product to your choice. Use this product for all locations where you require a hard wearing dust free coating. It can be used to paint over screeds, concrete, timber, plasterboard, bitumen, tarmac, most other paints.

• Very Fast drying
• No primer needed
• Clean tools with water
• Silk finish
• Solvent free
• Very easy to apply
• Good chemical resistance
• Slip resistant additive available

How to apply the paint

1. Clean up the floor, remove dust, oil or grease which may reduce the bond.
2. Open the base and hardener components using pliers.
3. Thoroughly mix the two together.
4. Apply by short pile roller to the floor.
5. Clean tools with water.

The paint will be touch dry in 2 hours and ready for foot traffic in 8 hours.

Normally 2 coats is advised for the best finish. Allow to dry between coats.